Wanna Dimmer relay

This module is an electronic relay to switch between low beam and high beam using a nonlatching switch. Pushing the switch button will change from low beam to high beam and vice versa.

Wanna Dimmer relay
This module is an electronic relay to switch between low beam and high beam using a nonlatching switch. Pushing the switch button will change from low beam to high beam and vice versa.
The module is designed to handle up to 60W (H4) bulbs continuously. 55W/60W 2 wire bulbs can be used too. The control wires from the module to the switch may have very small diameters.
Because the load on the control wires is very little, the light intensity of the lamp is not affected using small diameters.
 
Typically application:
• Replacement of OEM-Rocker switch for low beam and high beam.
• Replacement of electro-mechanic light relay.
 
Specifications:
Size: Cylinder 28 mm Æ x 15 mm (waterproofed sealed)
Voltage range: 6 - 14 V
Output current: max. 50/60 W (1 x 5.2 A @ 13.8 V) continuous
Input: Non-latching switches need connection to ground.
 
Attention:
The relay may be installed in vehicles with onboard diagnostic system (BCM, CAN-bus). In this case, output of DTC's (diagnostic trouble code) or other indication of male function may occur. After installation verify the correct function of ABS/CAN-bus if installed!
Only connect to 12 V DC power.